BW
BondWerksPrecision Bonding
Applications

Materials & Use Cases

Real-world applications for BondWerks ONE. Filter by material or project type to find your scenario.

Filter:
Furniture Joint Repair
wooddiy

Furniture Joint Repair

  1. 1Clean old glue residue from both surfaces.
  2. 2Apply thin bead of CA to one surface.
  3. 3Clamp or press firmly, spray activator.
  4. 4Allow to set before handling.
Handling time varies by wood type and joint fit.
Metal Bracket Reattachment
metaldiy

Metal Bracket Reattachment

  1. 1Lightly sand mating surfaces (220+ grit).
  2. 2Apply CA to one side, position bracket.
  3. 3Spray activator for rapid cure.
Sanding improves mechanical bond on smooth metals.
Ceramic Handle Repair
ceramicdiy

Ceramic Handle Repair

  1. 1Clean break edges -- remove dust and debris.
  2. 2Apply thin CA line along the break.
  3. 3Press and hold, spray activator.
Clean breaks bond best. Avoid gap-filling on ceramics.
Rubber Seal Rebonding
rubbershop

Rubber Seal Rebonding

  1. 1Lightly abrade rubber surface.
  2. 2Apply CA to one surface generously.
  3. 3Press seal into position, activate.
Flexible rubber may require testing for best results.
ABS Plastic Housing Fix
plastichobby

ABS Plastic Housing Fix

  1. 1Clean surfaces with isopropyl alcohol.
  2. 2Apply thin CA bead along crack or seam.
  3. 3Clamp or hold, spray activator.
ABS bonds well with CA. No primer needed.
PE/PP Plastic Repair
plasticshop

PE/PP Plastic Repair

Primer required for this material.

  1. 1Apply polyolefin primer to both PE/PP surfaces.
  2. 2Allow primer to dry per instructions.
  3. 3Apply CA, position, spray activator.
PE/PP require primer for reliable CA adhesion.
RC Wing Assembly
woodhobby

RC Wing Assembly

  1. 1Dry-fit parts to check alignment.
  2. 2Apply CA to joint, position wing section.
  3. 3Spray activator, hold until set.
Activator gives immediate set for alignment work.
Glass Ornament Repair
glassdiy

Glass Ornament Repair

  1. 1Clean both glass surfaces with IPA.
  2. 2Apply very thin CA line to one edge.
  3. 3Press together, spray activator lightly.
Use minimal CA on glass -- excess can cloud the surface.
Knife Handle Stabilization
woodshop

Knife Handle Stabilization

  1. 1Remove loose handle and clean tang.
  2. 2Apply CA into handle cavity and on tang.
  3. 3Seat handle, spray activator, hold steady.
Thin CA wicks into cracks; medium viscosity fills small gaps.

Don't see your use case?

Try the Bond Advisor for personalized steps, or contact support for specific material questions.

Try Bond AdvisorContact support